SAFETY
Sept-2018
14
COMPRESSED GAS EQUIPMENT
Gas cylinders should be mounted securely to a wall or other stable supporting
device.
Cylinders
Compressed gas cylinders must be handled and used in accordance with
appropriate national safety standards.
•
Never use a cylinder that is physically damaged or leaks.
•
Never move or transport a cylinder without the protective valve cover in place.
•
Never use a gas cylinder or its contents for any other purpose than that for which
it is intended.
•
Never lubricate cylinder valves with oil or grease.
•
Never allow electrical contact such as welding arcs with cylinders.
•
Never expose cylinders to excessive heat, sparks, slag, or open flames, which
may cause rupture.
•
Never use hammers, wrenches or other tools to open stuck valves. Send these
cylinders back to the supplier.
Pressure Regulators
All regulators used to operate plasma equipment must be maintained in proper
working condition.
Faulty equipment can cause equipment damage or operator injury. Faulty
equipment must be serviced at the manufacturers designated facility by trained
repair technicians.
•
Never use a regulator for any other gas than that for which it is intended.
•
Never use a regulator that leaks, excessively creeps, or is physically damaged in
any way.
•
Never attempt to lubricate a regulator with oil or grease.
Summary of Contents for CNC Plasma Cutting Table
