instruction Manual
attaching and removing the rest
Before attaching the rest to the cradle, please note that it
has a short and a long leg. the short leg is for the shoulder
side, the long leg is for the chest side. Each leg has an
adjustment screw and a tightening disc attached to it. the
cradle has two black tracks, into which the adjustment
screw head can slide. in order to attach the rest, start with
the shoulder leg.
unscrew the tightening disc until it sits almost half way up
the thread of the adjustment screw. slot the adjustment
screw head inside the track and slide it into the desired
position. tighten the disc, attaching the leg securely to the
cradle. repeat this procedure for the chest leg.
to remove the rest from the cradle, simply loosen the two
tightening discs, slide the heads of the adjustment screws
one by one towards the ends of the tracks and pull them
out gently.
adjusting the legs
hEight
the height of the rest can be extensively adjusted. remove
the rest from the cradle and rotate the adjustment screws
either into or out of the legs to achieve the desired height.
an extra high position on the shoulder can be achieved by
exchanging the medium adjustment screw for the long one.
if an extra low position on the shoulder is required, use the
alternative extra short shoulder joint and adjustment screw.
these alternative parts can be found among the accessories.
in addition, the chest leg and shoulder leg can be exchanged
to achieve a further variety of positions.
tilt
the tilt of the shoulder rest can easily be adjusted. attach
the shoulder rest to the cradle and slightly loosen all 4 of
its torx screws. adjust the tilt, either by swivelling the rest
or by rotating one or both of the legs. after deciding on
the tilt, tighten all the screws.
12 EN
Summary of Contents for KorfkerCradle Series
