Pool cleaning robot
18
6- Troubleshoot and light indicators
Symptoms
Cause
Solution
Comments
The robot is not
functioning
The pug is not
connected
Connect the plug
Please turn off the
power before
performing any
maintenance.
Bad connection
Check the
connections
Suction is weak
The helix is
obstructed
Clean the helix
The helix is
damaged
Replace the helix
The filter bag is full
Clean the filter bag
The robot always
rotates in the same
direction
A driver belt is loose
or broken on one
side
Replace the driver
belt
The filter bag is full
Clean the filter bag
The robot does not
climb on the walls
The filter bag is full
Clean the filter bag
A driver belt is
broken
Replace the driver
belt
Roller is worn out
Replace the roller
Roller axis is worn
out
Replace the roller
axis
The robot fails to
sink to the bottom of
the pool
Sponges are not
soaked enough
Hold the robot in the
water until foams are
soaked and press it.
There is air inside
the machine
Flip the robot in the
water and make sure
that the air escapes
Dirt comes out of the
flow guide
The filter bag is
unfastened or
broken. The dirt is
too fine for the bag.
Replace or correctly
reset the filter bag.
Note
: The power supply box must be
disconnected
from power before performing any
maintenance on the robot. Contact your local distributor for other problems not listed
here
