No Diving or Jumping. Observe all Safety Rules
GENERAL INSTRUCTIONS - BRACELESS OVAL POOLS
ASSEMBLING THE POOL WALL
Section
3
2-2. For HUNG/J or V-BEAD LINER ONLY
(Please see step 2-1. or 2-3. for other liner)
a. With a V-Bead liner you will
not use the plastic
coping strips
that are packed in the parts carton of
your pool. You can discard those pieces, if they are
included, as they only apply to pools with overlap
liners.
b. The top of the wall of the liner has what is called
a “V-Bead” welded onto it. Simply open up the
bead with your fingers and hang it directly on
top of the pool wall. When this is done properly,
the only portion on the outside of the pool wall is
approximately 1” of the V-Bead. No printed liner
material is actually going over the top of the wall to
the outside of the wall.
(Image 21)
c. Make sure the bead is on evenly around the entire
pool, and that the liner is hanging straight down
from the top of the wall. The liner should not have
creases in it because it is twisting around the pool.
If the liner is twisting, it is because it is not sitting
properly in the pool. Make necessary adjustments
before proceeding.
NOTE: Some liners may fit very tightly, it is better to
install uprights, top plate and rail before going onto
next step. See Section 4.
3. Proceed to Section 4 -
Installing the Pool Frame
C. CONT. INSTALL THE POOL LINER
21
Important Note:
Do not trim off the excess liner. (If the liner ever needs to
be removed, trimming the liner will make re-installation
very difficult.) Instead, roll up any excess liner and tape
it in place near the top of the pool wall.
3-9
