No Diving or Jumping. Observe all Safety Rules
Section
3
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
Section
3
d. To fasten the wall joint, overlap the two steel bars, one
on the inside and the other on the outside. Tighten the
mechanical screws on the inside and the nuts on the
outside. Ensure that all bolts and all the holes are used.
(Image 11)
e. Adjusting the pool to the proper shape may cause the
bottom rails and bottom plates to slip out of alignment a
little. Recheck all of the bottom plates to make sure each
one is centred where the bottom rails meet.
f. Cover the seam and bolt heads on the inside/interior
of the pool wall completely with 2” (50mm) duct tape.
(Image 12)
A. CONT. SETTING UP THE POOL WALL
11
Important Note:
Stick a screwdriver through two of the holes to help line up the
ends of the wall.
When tightening the screws start from either the
top and go down or vice versa. Do not start a few
screws from top and a few from the bottom to
meet in the middle, this can cause problems later
on.
Important Note:
The pool must be level across the perimeter. A pool that is not
level is dangerous and may collapse.
12
3-4
