No Diving or Jumping. Observe all Safety Rules
Section
3
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
Section
3
2-3. FOR OVERLAP ONLY
(Please see step 2-1. or 2-2. for other liner)
a. Starting at the liner wall seam, hang the liner over the
slotted tube making sure that the seam is straight up and
down, perpendicular to the floor. This will assure you that
the liner begins going over the wall straight.
(Image 20)
b. As you put the liner over the wall you can secure it by
using the plastic coping strips to keep it in place. If you
end up with excess material, continue around the pool,
pulling excess liner evenly, and distribute over the wall
until the excess is gone.
(Image 22)
c. Fasten the liner to the top of the wall with plastic coping.
Let the liner hang slack for now. Do not pull the liner tight.
(Image 23)
NOTE: Some liners may fit very tightly, it is better to install
uprights, top plate and rail before going onto next step.
See Section 4.
d. Turn the vacuum cleaner on and push the liner outward
with your feet to iron out any wrinkles. Once finished, turn
off vacuum cleaner.
e. Start filling the pool with water. As the pool fills, work out
all the wrinkles and smooth the liner to the wall. Remove
the plastic coping around the top edge of the wall one
piece at a time and adjust the liner. Keep smoothing out
the wrinkles.
3. Proceed to Section 4 -
Installing the Pool Frame
C. CONT. INSTALL THE POOL LINER
Important Note:
Do not trim off the excess liner. (If the liner ever needs to
be removed, trimming the liner will make re-installation very
difficult.) Instead, roll up any excess liner and tape it in place
near the top of the pool wall.
tape
tape
excess liner
excess liner
24
LINER
POOL WALL
SLOTTED TUBE
COPING
22
23
3-10
