AddressRight® DA400 Printer
Page 6 of 8
Installation Instructions
SV61187 Rev. B
Page 7 of 8
AddressRight® DA400 Printer
Installation Instructions
SV61187 Rev. B
5. Connecting the Power Cord and Turning the Printer ON
A. Make sure that the power switch is turned OFF (0), then connect the power
cord to the printer.
B. Plug the power cord into a
grounded
outlet. Please review the safety informa-
tion on pages 1-5 and 1-6.
Once you've connected the cable, press the printer’s power switch to the “I” (ON)
position. The switch is located next to the power cord receptacle.
When you turn the printer on. The LCD menu displays that the printer is initial-
izing. After a few seconds, the printer will automatically go "ON LINE".
You can tell if the printer is ON LINE, by looking at the green indicator light
above the ON LINE key. When the printer is ON LINE, the indicator will be lit.
6. Installing the Print Cartridge(s)
The printer uses Print Cartridges which you must now install before you can
print. Make sure the printer is OFF LINE before you install the print cartridges.
A. Open the Print Station Cover.
B. Remove the Cartridge from the shipping container by peeling the top cover
off. Be careful not to touch the copper ribbon.
C. Gently remove both pieces of tape covering the ink nozzles on the Print Car-
tridge. Be careful not to touch the copper nozzles.
Power cord and USB cable attached
Assembling the
Printer
(continued)
Power cord and Parallel cable attached
