Printer Basics • 2
2-9
SV61665 Rev. C
5. Position the Side Guide
Your printer comes with two side guides—a long one and a short
one. Use the long side guide for #10 or DL envelopes and larger
materials. Use the short side guide for materials smaller than a
#10 or DL envelope.
It is important that the side guide not be adjusted tight against
the media.
To position the side guide:
A. Place a sample piece or trial stack of material in the input
area.
B. Slide the side guide until it almost touches the stack of
material.
C. Check that there's about 1/16" (2mm) clearance (the
thickness of a dime) between the side guide and the stack.
NOTE:
Proper clearance is important. If you push the side
guide tight up against the stack, it could impede feeding and
cause jams. If the clearance is too great, pieces could skew as
they feed into the printer.
Adjust Side
Guide to media
width.
Summary of Contents for AddressRight DA70S
