SDC2035C Communication Device Advanced Setup Guide
EN
<< Return to Contents
1. Connect the Communication Device
a. Connect the Communication Device to your network as shown.
b. Plug the AC power adapter into
the Communication Device and
a power outlet. The left LED is lit
yellow when it is on.
c. After a short time, check that the
right LED is blinking orange and/
or green.
Setting up a wireless (Wi-Fi) network connection
Introduction
The Communication Device can be setup for wireless usage, enabling you to move
your Franking Machine to any location that is within the range of a wireless access
point on your network.
You should have a working knowledge of your wireless network in order to
complete the setup successfully. Follow the steps below. If at any point you are not
certain how to proceed, consult with your IT specialist/network administrator.
Before setting up the Communication Device for wireless operation:
• Have the name (i.e., SSID) and password (i.e., key) available for your wireless
network/router. The SSID may be printed on the bottom of your wireless router.
• Find out if any special settings are necessary to install a new device on your
wireless network, such as static IPs, proxy servers or non-standard wireless
network settings.
• Ensure the Wireless USB Plug-in is installed in one of the USB ports in the
Communication Device (see illustration).
• Be sure a wireless access point (transmitter) is
close enough to the location of your Franking
Machine to have good signal strength.
• Determine if your network supports Wi-Fi
Protected Setup.
You can do this by checking your router documentation or looking on the router
to see if it has a button labelled “WPS” or the symbol
If it supports WPS, you may choose to follow the instructions “Wi-Fi Protected
Setup” later in this guide instead of performing the standard Wi-Fi setup
instructions on the following pages.
USB Plug-in
• If you are installing your Franking Machine and have just taken the
Communication Device out of its box, it will be in the factory default state and
you can continue with the steps below. If the Communication Device has been
confi gured and used before, fi rst reset it as described
here
before proceeding.
LAN connection (Router,
Hub, Wall socket)
Network Cable
Communication
Device
LEDs
AC Power Adapter
LEDs
