Pitney Bowes E589 Series, Operating Manual

FCC Compliance - Mailing Machine

“Note: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against unwanted interference when the equipment is
operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions manual, may cause unwanted
interference to radio communications. Operation of this equipment in a residential area
is likely to cause unwanted interference in which case the user will be required to
correct the interference at this own expense.

“Shielded cables must be used with this unit to insure compliance with the Class A
limits."

Canadian DOC Compliance

This digital apparatus does not exceed the Class A limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.

Le présent appareil numérique n’emet pas de bruits radioélectriques depassant les
limites applicables aux appareils numériques de la class A prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministèr des Communications
du Canada.”

Due to continued product improvement, machine specifications may differ from those
in this publication.

Important Safety Information

In some countries the mailing machine is supplied with a molded mains lead (power
cord) and plug. In other countries, or if the supplied lead is not used, the following
information applies:

1. An approved mains lead for the country concerned must be used.

2. As the colors of the wires in the mains lead of this appliance may not correspond

with the colored markings identifying the terminals in your plug, proceed as
follows: The wire which is colored green and yellow must be connected to the
terminal in the plug which is marked with the letter “E” or by the earth symbol
or colored green or green and yellow. The wire which is colored blue must be
connected to the terminal which is marked with the letter “N” or colored black. The
wire which is colored brown must be connected to the terminal which is marked
with the letter “L” or colored red.

3. The wires in the supplied mains lead are colored in accordance with the following

code:  green and yellow - earth, blue - neutral, brown - live.

WARNING - THIS APPLIANCE MUST BE GROUNDED.

The socket outlets should be near to the equipment and should be readily accessible.

SV60975 Rev A 10/02      ©2002 Pitney Bowes        All rights reserved.   Printed in U.S.A.