2-16
SDC927D
2 • Operation
The normal response to this is to select
Green
to deactivate, and the
material will transport from F767 to the Inserter.
TIP:
Should you want to test any aspect
of the job setup before the material
is transported to the inserter, select
Red (No) to the prompt and the
sheets will be stacked in the F733
Outsort Tray.
Deactivate Inline
Test?
You only need to carry out this step if you are NOT using the F774/F772
High Capacity Loaders. If the loader IS being used, it will automatically load
sheets onto the F767's Feed Deck. See F774/F772 setup on the next page.
Flex and aerate the material stack to
ensure good separation.
Position the stack on the Feed Deck
in the correct orientation for the job
being run:
1
Face up, bottom first
2
Face up, top first
3
Face down, bottom first
4
Face down, top first
IMPORTANT:
Fan the paper stack as
shown in the photograph, with the bottom sheets in the stack leading.
TIP:
When initially loading the paper stack, load about 200 sheets then fully load
the feeder once you commence operation. The F767 can be reloaded while
the system is in operation.
Load Paper
Summary of Contents for F767
