4-2
SDC927D
4 • Troubleshooting & Maintenance
To access the User Menu functions:
Press the
Green
,
Blue
and
Red
buttons at the same time.
Use the
Arrow Buttons
to select ‘User Menu’, then press
Green
to confirm.
The User’s
Menu
Select: USER MENU
<-->=SELECT Green=Confirm Blue=EXIT
The User Menu offers the options listed below. Use the
Arrow Buttons
to
select an option, then press
Green
to confirm.
When you are finished with any option, press
Red
to go to the next
selection.
Material Feed Belt Cleaning
The Material Feed Belts should be cleaned if the belts appear contaminated
and/or if material feed is sluggish.
This option allows you to stop and start the belts using the
Green
button to
facilitate cleaning.
Press the button momentarily and the feed belts will run for approximately 3
seconds. Press and hold the button to run the feed belts continuously.
It is recommended that the material feed belts are cleaned weekly with
water and a good quality cloth.
BCR Test
This function allows you to test that a BCR scanner is reading a code.
When selected, the scanner red lights will flash slowly. Manually position
the bar code above or below the scanner as applicable. If the code is read
successfully, the lights will flash faster and the characters read will display
on the operator display.
Total Feed Cycles
This option displays the total cycles that the F767 has performed.
Motor Test
LED and Key Test
Show Sensor Status
Double Feed Adjust
These are primarily for service use. Only access these options at the
request of a representative of your machine supplier.
Options
Available
Summary of Contents for F767
