SV62781 Rev. B
| Operator Guide
2 | SH2A Shredder
Important Safety Notes
Follow the normal safety precautions for all office equipment.
• Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper storage and
use of aerosol dusters or flammable aerosol dusters, can cause an explosive-like condition that
could result in a personal injury and/or property damage. Never use aerosol dusters labeled
flammable and always read instructions and safety precautions on the duster container label.
• To obtain Pitney Bowes supplies, please contact our Supply Line™ to place orders. Material
Safety Data Sheets can be obtained on the web or from our Supply Line™.
• Use the power cord supplied with the system and plug it into a properly grounded wall outlet
located near the system and easily accessible. Failure to properly ground the system can result
in severe personal injury and/or fire.
• Do not remove covers or defeat safety interlock switches. Covers enclose hazardous parts that
should only be accessed by properly trained service personnel. Immediately report to Pitney
Bowes Service any damaged or non-functioning components that renders the unit unsafe.
• Place the unit in an accessible location to allow for proper venting of the equipment and to
facilitate servicing.
• The power cord wall plug is the primary means of disconnecting the machine from the AC
supply.
• Do not use an adapter plug on the line cord or wall outlet.
• Do not remove the ground pin from the line cord.
• Avoid using wall outlets that are controlled by wall switches, or shared with other equipment.
• Do not route the power cord over sharp edges or trapped between furniture.
• Insure there is no strain on the power cord where it becomes jammed between the equipment,
walls or furniture.
• Be certain the area in front of the wall receptacle into which the machine is plugged is free from
obstruction.
• Read all instructions before attempting to operate the equipment.
NOTE:
Always follow the specific occupational safety and health standards for your workplace.
©2012 Pitney Bowes Inc. SV62781 Rev. B (January, 2012)
Due to publication lead times and continuing product development, this manual may not reflect final
product release configurations and recommended service procedures. Equipment and material
specifications as well as performance features are subject to change without notice. Available
product features may vary, depending on machine model, system software level and system setup.
Some product features may be country specific.
Company names, products or services mentioned herein may be protected by trademarks,
registered trademarks or service marks and are the property of their respective owners.
All rights reserved. This book may not be reproduced in whole or in part in any fashion or stored in a
retrieval system of any type or transmitted by any means, electronically or mechanically, without the
express written permission of Pitney Bowes.
