Boomilever Adapter User Guide 57760 V0511
1. Use screws to attach the short side of the support brackets to the
predrilled holes in the Boom-I-Lever vertical test wall (Figure 1).
2. Draw a line across the structure tester tabletop 5-1/2" from the edge
you have selected for mounting the Boom-I-Lever test wall.
3. Center the test wall
on the line so that the
support brackets face
the hole in the middle
of the structure tester
tabletop (Figure 2).
4. Mark the position
of the holes in the
support brackets.
Remove the test wall,
and drill the holes.
5. Replace the test wall
and use screws to
attach the support
brackets to the
structure tester
tabletop.
Now that you are ready, use the Boomilever as shown below.
Illustration of the Boom-I-Lever Adapter being
used to test a cantilever.
5-1/2"
Figure 2
