Got questions? We’ve got answers!
4
Call 800-358-4983
Floor Setup
1 . At the start and finish ends of the track location, fasten
the black ABS line anchors to the floor with duct tape
(Figure 2) .
2 . Locate the spool of monofilament line . Tie a loop in the
end of the line – use a knot such as the overhand or
figure eight (Figure 3) .
3 . Hook the loop over one of the anchor screws on the
ABS line anchor .
4 . Walk to the opposite end of the track, allowing the line
to unreel from the spool as you go . Extend the line just
past the anchor and cut it .
5 . Tie a loop at this end of the line using the overhand or
figure eight knot so the loop is approximately 24 inches
short of reaching the anchor screw . For example, if the
track is 80 feet long, tie a loop in the line so the length
of the line plus the loop is 78 feet long . The line should
be tightly stretched . A tight line should prevent cars
from going off course as they race down the track . Cut
off any excess line extending from the loop’s knot .
Note:
If your track is shorter than 80 feet, 24 inches short
of the anchor screw might make the line overly tight .
6 . Repeat Steps 2-5 for the other lane .
7 . Attach the strips of Velcro material to the black rectangles on the start mat .
8 . Place the start mat in position, sliding it under the two monofilament lines . Align the arrows on
the mat with the two monofilament lines .
FasTrak Elevated Racetrack Setup
Follow the procedures outlined in the FasTrak User’s
Guide for setting up the track and stretching the monofila-
ment line .
Gate Assembly
The start and finish gates will come unassembled . To
assemble them, simply attach the legs of each gate with
the four screws, screwing two in each side of the gate
(Figure 4) . Now the gates are ready to be used .
Caution:
Do
not
overtighten the screws .
Figure 3
Figure 4
Figure 2
