Midi2 Module
!
!
Description
The Midi2 converts standard midi note messages into the analog control voltages used by modular synthesizers. This allows a modular
synthesizer to be controlled by a midi keyboard, sequencer, or DAW.
The Midi2 module has 3 distinct modes of operation set using the switch
on the front panel.
1. Monophonic - (M) Gate2 and CV2 outputs mirror the outputs of Gate1 and CV1. Monophonic mode works great when using a modular as a
single voice synthesizer.
2. Duophonic - (P) The Midi2 module uses the two sets of Gate and CV outputs to allow two notes to be played simultaneously. The first midi
note is sent to the Gate1 and CV1 outputs and the second is sent to the Gate2 and CV2 outputs. Duophonic mode is perfect when working
with a two voice modular synthesizer.
3. Dual Monophonic - (D) Gate 2 and CV2 outputs are controlled by a different midi channel than the Gate 1 and CV 1 Outputs.
Dual
Monophonic mode allows a modular to be controlled by two separate sets of midi data. This mode works well when using a modular as two
single voice synthesizers.
!
Controls
GT1 Output – Note on = Gate high (+5v), Note off = gate low (0v).
CV1 Output – 1 volt per octave voltage derived from note played on keyboard.
GT2 Output – Note on = Gate high (+5v), Note off = gate low (0v).
CV2 Output – 1 volt per octave voltage derived from note played on keyboard.
Sync Output – Outputs gate based on beat 1 of the incoming midi clock.
Midi Input – Input jack for a standard 5-pin midi cable.
!
!
8