Page 5
For technical questions, please call 1-800-444-3353.
Item 69887
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Mounting Engine
TO PREVENT SERIOUS INJURY:
Before attaching an engine to the stand, confirm that its weight
does not exceed the Stand maximum capacity.
1. Remove the Pin (4) from the Post (5).
2. Loosen bolts holding Mounting Arms (9)
and align them with four mounting
bolt locations on the engine.
WARNING! Use all four Arms when
attaching an engine to the Stand.
3. Place the bolts (not included) through
the Mounting Plate (8) side and securely
tighten them into the engine.
The bolt heads must press
against the back of the Arms:
if needed, use flat washers
(not included) as spacers.
4. Tighten the Bolts (10) and Nuts (6)
that hold the Mounting Arms (9) to
the Mounting Plate (8) securely.
5. Slowly lower the hoist/engine crane
(sold separately) until all the engine’s
weight is held by the stand.
6. Safely release the engine from
the hoist/engine crane.
7. Slowly rotate the engine to the
desired angle and insert the Pin (4)
into the top of the Post (5).
Rotating Engine
TO PREVENT SERIOUS INJURY: Be prepared for sudden engine
movement before removing Pin. Stay clear of engine.
1. While holding onto the Handle (2)
and the engine to prevent it from
accidental rotation, remove Pin (4).
2. Use assistance to rotate the engine
to the desired angle and insert the
Pin (4) into the top of the Post (5).
Removing Engine
1. With assistance, rotate the
engine to its initial position.
2. Secure the engine properly to the crane.
Use the crane to support all of the
engine’s weight directly overhead, but
do not start lifting the engine stand.
3. Once the engine is properly supported
by the crane, remove the bolts securing
the Mounting Arms (9) to the engine.
Summary of Contents for 69887
Page 1: ......
