- 13 -
10 - MAINTENANCE
11 - REPLACEMENT OF THE HOSE
11.3
11.4
11.1
11.2
11.5
IMPORTANT: Any maintenance operation shall be carried out by a suita-
bly trained staff, following carefully the information given in this manual.
Ensure that there is no tension in the spring before starting any opera-
tions inside the hose reel.
Always close the feeding of fluid to the machine before carrying out any maintenance on it.
Replace the flexible hose as soon as it shows any sign of wear and tear or of deterioration
due to the different conditions of the labour environment. We advise you to replace it every
year in case it is used for a few hours a week.
Replace the seal inside the revolving joint in case of losses due to wear and tear. Any repla-
cement of hose reel parts has to be done using original spare parts.
We advise you to contact the manufacturer for any possible anomaly and before replacing
any part. After every maintenance operation, put again the eventual supports.
Replace the hose with another one of the same
dimensions and characteristics.
11.1) Remove the hose rubber stopper and release
the hose slowly until the spring is completely
unloaded.
11.2) Remove the plastic protection and loosen the
swivel joint.
11.3) Loosen the two screws of the spring likage shaft
by a 10 wrench.
11.4) Disassemble the opening on the spring side and
unwind completely the hose from the drum.
11.5) Take out the drum, unscrew the internal fitting
with the suitable wrench and mount the new
hose (see the chapter "Hose assembly").
11.6) Assemble again the hose reel, by following the
above steps in reverse order. If that is the case,
grease the supports and the ratchet hook.
11.7) Go on as indicated at the chapter: "Mounting of
the hose".
WARNING! For safety reasons, ope-
rations of hose replacement must be
carried out at the bench.
EN
DO NOT PUT HANDS OR ANY OTHER
THING INSIDE THE DRUM!
