21
step 8
Carefully slide your HDD into the
cage from the left as show in the
diagram. The base of the HDD
should be touching the top
plate. Make sure point X and Y
are aligned.
Y
X
step 9
Insert the 4 HDD
screws into the holes
shown in the diagram
and tighten.
step 12
Carefully slide the
cage back into the
case, by lining up the
plates and grooves as
shown in the diagram
step 13
Re-insert the 3 screws into the rear panel of HD
MediaBox.
The internal HDD is now ready for use. If the HDD is
not formatted, please see the next section.
step 10
Turn the cage around so that you can see
the HDD connectors.
step 11
There are 2 connectors, 1 on a ribbon
cable (the IDE cable) and one with 4
wires (the POWER cable). Connect both
these cables to your HDD.