1) The product wireframe drawings in this document
are intended for illustration purposes only and may
differ from the final physical product.
2) The installation instruction is subject to change
without prior notice.
3) NO DIY, installed by a licensed electrician only.
Due to continued product and information updates, product data included herein shall not form part of any contract and or technical
performance guarantee unless expressly confirmed in writing by SAL at the time of order.
SAL National Pty Ltd. 40 Biloela Street Villawood NSW 2163
ABN 21 633 189 474
4.3 Reset
Resetting the device will return it to its default settings / factory settings and
users will need to follow the Touch Panel setup procedure again.
Make sure the touch panel is powered. Remove the faceplate, using
the pin key provided in the pack, insert it gently into the hole indicated as
SET on the top of the touch panel main body, press and hold the button for
15 seconds until the screen turns off, then release. This is a factory reset, all
the data will be cleared and the Touch Panel can be reconfigured again.
