~
79
~
WARNING!
While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
CAUTION!
When installing the appliance, ensure optimal heat
radiation to maintain the operating safety.
CAUTION!
The wall and the reach of the heat radiation above the
worktop must be made of heat-resistant materials.
CAUTION!
To avoid any damage, the sandwich layer and adhesive
must resist heat.
The customer is responsible for the installation. If the manufacturer´s help is
needed to repair any damage due to improper installation, this repair work is not
covered by the guarantee. Improper installation may cause serious personal
injuries and/or property damage. The manufacturer cannot be held liable for such
injuries or damages.
2.1 Unpacking and positioning
1.
Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2.
Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3.
Check that the appliance and the power cord are not visible damaged.
4.
Install the appliance in a dry and well-ventilated place.
5.
Do not install the appliance in a place where it may come in contact with water
or rain; otherwise, the insulation of the electrical system will be damaged.
6.
Install the appliance on a
level, dry and solid floor
. Check the correct installation
with a bubble level.
7.
Remove the complete packaging material (inside and outside the appliance)
before initial operation.
8.
Connect the appliance to the mains properly.
9.
Manufacturing residues or oil having remained in the appliance or on the heating
element may cause some odours and smoke emission. These are normal
operational parameters, which will disappear after several uses. Open the room
door or a window to ensure proper ventilation.
10.
The nameplate is situated inside the appliance or at the back.