74
NOTICE!
You must fill the container when the salt indicator has gone on.
As long as the salt has not dissolved, the indicator may stay on even the
container is full. If there are spills of the salt, a soak or rapid programme
should be run to remove excess salt.
4.2.1 Adjusting of the salt consumption
S
TEP
1:
E
NTER MODE
Open the door.
Switch on the appliance using the
ON
/
OFF BUTTON
(1).
Within 60 seconds after you have switched on the appliance press the
PROGRAMME BUTTON
(7 / s. chapter 3.2 C
ONTROL PANEL
) for 5 seconds.
The appliance is in the salt-setting-mode now.
The display indicates the current status of the salt consumption, e.g. H 4.
S
TEP
2:
S
ETTING OF THE SALT CONSUMPTION
Press the
PROGRAMME BUTTON
(7) to select a suitable setting corresponding to
your local requirements.
The settings are consecutively numbered H 4 -> H 5 -> H 6 -> H 1 -> H 2
-> H 3
S
TEP
3:
E
XIT MODE
When you have not made an input for more than 5 seconds, the appliances
changes into the stand-by mode.
There are 6 levels of salt consumption. We recommend to set the level relevant
to the schedule below.
You can receive all relevant information about the local water harness range
from your water supplier.
