35
damaged must be repaired by a qualified professional.
All repairs should be performed
by your authorized after sales service.
Unpacking and Positioning
1.
Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2.
Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3.
Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4.
Check that the appliance and the power cord are not damaged.
5.
Install the appliance in a dry and well-ventilated place.
6.
Protect the appliance from direct sunlight.
7.
Do not install the appliance in a place where it may come in contact with
water/rain; otherwise the insulation of the electrical system will be damaged.
8.
The doors must open completely and without hindrance.
9.
Install the appliance on a
level, dry and solid floor. Check the correct installation
with a bubble level.
10.
Connect the appliance to the mains properly.
11.
The nameplate is situated inside the appliance or at the back.
Dimensions - appliance
