5. INSTALLATION AND CONNECTION TO THE MAINS
WARNING !
Do not use a socket board or a multi socket when using 220 V
– 240 V/50 Hz alternate current (AC).All electrical connections
which may be damaged must be repaired by a qualified
professional.
All repairs should be performed by your authorized aftersales service.
1. Unpack the appliance carefully. Strictly observe the information concerning the disposal of
the packaging in chp. waste management.
2. The appliance is not design to be built-in.
3. Install the dryer in a clean room. The air inlets of the appliance must not be blocked by any
items or materials. Install the appliance on a solid ground floor only to avoid vibrations and
noise.
4. Do not install the appliance on floors which cannot resist high temperatures.
5. The hot air the appliance generates can reach temperatures up to +60
0
C.
6. The room temperature during the use of the appliance must be b5
0
C and +35
0
C.
7. Install the appliance in a proper distance to sources of heat and cold.
8. Before you install the appliance, check if the power cord and the appliance itself is not
damaged.
9. The appliance must be connected to a properly grounded and protected socket only.
10. Install the appliance in a dry and well-ventilated room.
11. The appliance is designed for indoor use only.
12. Protect the appliance against direct sunlight.
13. Install the appliance on a solid and dry ground floor. Use a water level to check if your
appliance is properly positioned.
14. The appliance must not stand on the power cord.
15. The model plate is on the appliance.
WARNING !
All electrical work must be performed by a qualified
professional only.
The appliance must be properly grounded.
1. Only run the appliance with 220V ~ 240V / 50Hz alternating current (AC). Only use a
suitable socket near the appliance.
2. The appliance must be properly grounded. The appliance is equipped with a 3-phase
grounded plug. Use a suitable safety socket to minimize the risk of electric shock.
3. Check if the voltage of your local energy supply meets the requirements given on the model
41
Electrical connection
Electrical connection
Unpacking and positioning
Unpacking and positioning