Plug one end of the DVI cable into the DVI port on the interface plate. Turn the screws
to secure the connection.
Plug the power supply cord into the power connector on the interface plate.
Plug the other end of the DVI cable into the Video 1 port on the installed DX board.
Plug one end of the power cord into the power supply.
Plug the other end into a grounded AC outlet.
9
Back of computer
DX board
Video 1
Vid
eo 2
1
2
3
4
5
3
Connect the first display of a two-headed
system or the only display of a one-
headed system to the Video 1 port.
For multiple display setups, connect
all displays to the DX boards before you
turn on the system to install the driver.
The driver can then detect all displays.
dx-qs-user-guide-5 3/23/04 11:15 AM Page 9
