2
Important Safety Instructions
1.
Read the Safety Instructions carefully and keep it for later use.
2.
Beware of all warning and instruction signs marked on the products.
3.
When cleaning, cut off the electrical supply at all times. Never use liquid or aerosol detergent, use a
damp rag instead.
4.
Always keep the product away from heavy moisture.
5.
keep this product stable at any time. Otherwise the product may fall, hazarding the safety and causing
serious damage.
6.
Do not clog apertures on the product's coating, required for ventilation purpose. Do not install this
product in built-in installation without proper ventilation system. Always keep this product away from all
kinds of heat sources.
7.
The power source used for this product must match one marked on the product's label. Please consult
your dealer or local utility if you have any doubt.
8.
In order to avoid the electric shock hazard in use, a 3-wire type plug with a grounding pin is provided.
Do not use any kind of plug without grounding.
9.
Do not lay the power cord on the pathway or rest anything heavy on it.
10.
Check the current flow tolerance of an extension cord before use, make sure that the total amount of the
product's current flow does not exceed the limit. A current flow of a wall outlet can never exceed up to
15 amperes.
11.
Do not insert objects or pour liquid into this product through it's casting apertures. It may touch a high
voltage area causing an electric shock or short the circuit.
12.
Do not attempt to repair the product your self or remove the casting. It may expose you to electric shock
hazard. Contact a dealer near you for the service.
13.
Do not unplug the power cord under the following circumstances. A qualified field service electrician is
needed.
a. When the power cord is damaged or frayed.
b. If liquid has been poured into the product.
c. If the product has been exposed to rain or heavy moisture.
d. If the product can't be adjusted and operate properly by following the operating
instructions. Intent to do the more advanced adjustments yourself may cause extensive
work for field service electrician.
e. If the product has been dropped or the casting is broken.
f. If there is a dramatic change of the performance.
14.
A proper type of power cords has been selected according to the country of destination and must be
used to prevent electric shock.
