11
Information
Provide information about resolution, H/V frequencies,
and polarity of the input signal.
Input Select
This OSD informs the user the current signal that is
displayed.
This OSD will automatically turn off after 2 seconds or by
pressing the “Exit” key.
OSD Warnings
NO SIGNAL
This OSD gives a warning when the selected input signal
is not active. After power on or when the input signal
become inactive, this warning appears.
No signal OSD shall be shown after around 0.5sec from
video mode detection. This OSD shall be turned off after 5
seconds automatically, or by “EXIT” key. Then change to
power saving mode. If direction key is pressed during
power saving mode, this warning OSD is opened again.
OSD Warnings
OUT OF RANGE
This function gives warning about input resolution or
refresh rate that the monitor cannot display.
If video signal is not at the proper timing when the
monitor powers on or input signal is changed, this
message opens and it disappears after 45 seconds, or by
"EXIT" key.
