5
Adjust height and angle of Tilt stand
The monitor screen may be raised or lowered and tilted (-5 to 40 degree).
To raise or lower the monitor screen, place hands on each side of the
monitor screen and lift or lower to the desired height as shown in the right
figure.
40
o
5
o
170
o
170
o
Figure 1-1
CAUTION:
* When lowering the monitor screen avoid catching your hand and fingers
between the monitor screen and the tilt stand base.
*The monitor screen can be tilted back to over 180 degree for packing.
When operating the monitor, do not tilt pass 40 degrees to prevent the
monitor from falling backward or being damaged due to increased
temperature within the monitor.
*Before tilting the screen back to 180 degree for packing, lower the screen
down to the lowest position to prevent the monitor from falling over and
being damaged.
*Do not push the surface of the monitor screen strongly and do not scratch
it with your nails when you adjust the position of the monitor screen.
Otherwise you might be injured or the display could be damaged.
40
o
-5
o
60cm
40
-5
o
Figure 1-2
Note:
When you tilt the monitor pass 40 degrees, you will hear clicking noise. Tilting pass 40 degrees becomes harder than tilting
within 40 degrees.
.
Connecting the Display
1. Power off your computer.
2. Connect one end of the signal cable to the LCD Monitor’s VGA
port or DVI port. (See Fig 1-3)
3. Connect the other end of the signal cable to the VGA port or
DVI port on your PC.
4. Make sure connections are secure.
VGA Port
DVI Port
Figure 1-3
