Planar PXL2251MW, User Manual

6

INSTALLATION INSTRUCTIONS 

STAND BASE INSTALLATION

The monitor is supplied complete with a stand.If you prefer to wall mount the monitor, 
please follow the instructions on page 21 to remove the stand. Be sure to include the stand 
with the monitor if it is necessary to return the unit.

CAUTION

 • Put the monitor on a stable surface.The monitor may cause injury or 

damage if it falls or is dropped.

 • Do not give a strong impact to the monitor.It may cause damage.
 • Unplug the monitor before removal or installation to avoid electric shock 

or damage.

<Installation>

1.  Put a piece of soft cloth on the table beforehand to prevent the monitor from being 

scratched. Lay the monitor flat on a table with front face down.

2.  Install the Stand-Base to the Monitor.
3.  Fix the monitor to the stand by using the screw. Once screw is securely fastened, push 

down the knob on the scew.

Stand-Base

Screw for Stand-Base fixing

Push down knob on screw

<Remove>

1.  Put a piece of soft cloth on the table beforehand to prevent the monitor from being  

scratched. Lay the monitor flat on a table with front face down.

2.  Pull up the knob of the scews, and remove the screws and the Stand-Base.

<Stopper pin>

Please stand the monitor up. Push down on the 
top face of the stand while slowly pulling out 
the stopper pin on the back of the stand. Careful 
attention is required as the monitor is sprung 
loaded and may expand quickly when removing it.

Stopper pin