Safety Information
Planar UltraLux Series Installation Guide
11
Safety Information
This display was designed with safety in mind. If you don’t heed the safety warnings
and cautions, you could get hurt. The safety warnings are on stickers in various places
in and on the display.
Important Safety Instructions
1
Read these instructions.
2
Keep these instructions.
3
Heed all warnings.
4
Follow all instructions.
5
Do not use any of the Planar UltraLux Series products near water.
6
Clean the optically bonded protection glass (ERO
TM
) with a 50-50 mix of water and
isopropyl alcohol with cheesecloth.
7
Do not install near any heat sources such as radiators, heat registers, stoves or
other apparatus (including amplifiers) that produce heat.
8
Do not defeat the safety purpose of the polarized or grounding type plug. A
polarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third
prong is provided for your safety. When the provided plug does not fit into your
outlet, consult an electrician for the replacement of the obsolete outlet.
9
Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles and the point where they exit from any of the Planar
UltraLux Series products.
10
The AC input is protected by a 5A slow blow fuse located in the AC inlet module.
The fuse is replaceable and the recommended fuse is Schurter part number
0034.3124.
11
Only use the attachments/accessories specified by the manufacturer.
12
Unplug all Planar UltraLux Series products during lightning storms or when
unused for long periods of time.
13
Ensure that the RUN/SVC switch on the control module is in the “Run” position
unless the display is being serviced. This will ensure that if one power supply fails
that the backlights will be reduced by 50% to save power.
