4.0 INSTALLATION:
The Planet Model ULED arm is designed to be mounted above the immediate work area. Standard mounting fixtures for
Planet Model ULED are: Ceiling Mount & Wall Mount (specialised mountings are available on application). In all cases the
suggested mounting height (measured at swivel head) is two metres from floor level. (refer Fig 1)
To ensure correct balance of the Model ULED movement the lamp must be mounted with the stem, around which it
rotates, vertical at all times.
(refer Fig 1)
WARNING
The qualified electrician who is responsible for the installation of the ULED must include an isolation switch
(all -pole disconnection) in the fixed wiring of the ULED and a cable tie near the terminal block of the primary (240V)
wiring (Phase and Neutral) to secure the cables.
Figures 2 - 4 Refers to wall mount options, Figures 6 - 8 Refers to ceiling mount options, Figures 9 - 11 Refers to maintenance
procedures
5.0 WALL MOUNT:
WARNING
Ensure before commencing the installation, that the MAINS power circuit is isolated (off).
CHECK AND ENSURE THE FOLLOWING BEFORE COMMENCING INSTALLATION:
• You have the appropriate mounting template.
• You have appropriate tools for the job.
• Confirmed mains cable entry is located appropriately.
• The mounting structure is suitable.
•
The structural loadings and approx product weights (refer Fig12)
• You have appropriate fixing attachments. e.g. Dyna bolts, large screws
5.1.0 Using appropriate wall template (template 1) mark mounting holes and mains cable entry. Make sure the bottom of
the template wall mount is 2055mm from the floor to maintain 2000mm clearance at the bottom of the swivel. (ref Fig 1)
5.2.0 Drill 4 mounting holes as shown on template 1.
Fig: 2
Classification: Non invasive med-
ical device, as per label/s below.
