5 Mega-pixel Vandalproof IR PoE IP Camera
ICA-E5550V
64
An example will help you gain a better sense of how to utilize this unique function. Camera A is
a fixed camera that looks at a corridor leading to the main hall. It has a motion detection
window located near the point where the corridor arrives at the large hall. Camera B is a PTZ
camera located in the hall, which is usually left on auto-tour patrol. When motion activity in the
motion detection region triggers MD1 in Camera A, this then in turn activates an event rule in
Camera A that gives out a command to Camera B. Camera B would then swivel to the preset
point where the corridor leads into the entrance and switch to higher bit rate to temporarily
provide clearer image. After the event ends, Camera B will go back to its normal routine in
lower bit rate.
To setup HTTP servers, make sure to enable the HTTP server, enter the user name, the user
password, Network (HTTP Server) address, Network (HTTP Server) port number and Max
connection time before timeout (in seconds).
After changing any of the items above, press
Apply
to save the changes. The Reset button
undoes the changes that had just been made but not Applied yet.
3.10.2 Event Configuration
Event configurations
are the responses to be performed when an event is triggered. For
most types of responses, you can create several different preset responses, then mix and
match in event rules.
The configurable responses are classified as Digital I/O ports, Notification messages, Upload
Video/Snapshot and Audio and Send URL Commands.
