5 Mega-pixel Vandalproof IR PoE IP Camera
ICA-E5550V
72
Potential uses include changing the motion detection profile to another set of Event MD
parameters. By having two sets of parameters each optimized for day and night, this provide
better overall accuracy in both day and night conditions. Some night time only MD regions may
also be activated this way. The event period will end when the camera returns to day mode,
which will then reset the camera to the original settings.
Device boots successfully
: This will trigger the event responses once the device boots up.
You can use this to create a notification system that keeps record of when the device has been
rebooted via email.
Reboot device
: This triggers the event response when the device is shut down via web UI
“Save and Reboot”. Use this to keep record of when was the device setting edited. Note that
this will not take effect when the device is unplugged, as this is not normal shutdown.
Fail to write storage
(with storage card only): Trigger occurs when there is an error in writing
data to the memory card.
Remove storage media
(with storage card only): Trigger occurs when the memory card is
suddenly removed from the device.
What responses will occur?
Available responses vary depending on what triggered the event.
Digital Output
(selected models only): This is a useful link to other devices. Click to include
this in the response for this rule.
Send notification Message
: Select from the three pre-defined messages which you’ve setup
in the Event Configuration section. You may enable multiple messages at the same time. For
sending Email, please limit the recipient to one per event rule. If you need to send email to
more than one recipient, please use separate event rules triggered by the same trigger.
Upload video/snapshots
: Select which of the event configurations to include in this response
set. If you are sending email via upload video and sending notification message at the same
time, the system will automatically merge the two emails into one. The subject and image will
be based upon the Upload snapshot Event configuration enabled, but the message in the body
text will be based upon the Notification messages.
In general, please stick to the “one email per event rule” limit for best performance.
Change Motion Detection profile
: This will switch the profile of the selected Motion Detection
region from Runtime profile to Event profile. The profile will return to runtime settings at the
end of this event. You may program one motion detection region to be disabled at runtime, but
enable it with event handler under some circumstances.
Send URL command
: Select the URL command to include in the response set. Two different
commands will be sent at the time when the event is triggered and un-triggered. For example,
going to a preset point, if the device is a PTZ camera, and there are preset points already
configured in PTZ setup page, then you may include this in the response section of the event
rule by using Send URL Command method. It is possible to let the camera return to another
preset point at the end of the event.
