Confidential
Filename: PS-IHD-410 Series_v1.0.doc
Page 9 of 12
Printed on 01/23/2017
Product Specification of IHD-410 Series
Interfaces Definition:
Position
Description
Function
1
Ethernet (PoE)
Connect to a LAN Switch.
IGMP snooping and Jumbo Frame supported Gigabit IEEE 802.3af/at
PoE+ Ethernet switch is recommended.
LED:
1. LAN LED (
green
color):
This LED will be flashing while network is accessing via Ethernet.
2. Power LED (
orange
color):
When the device is powered on, and the device is connected to
Ethernet switch, the LED will be always on.
2
HDMI
Transmitter: HDMI Type-A female connector for connecting to the HDMI
source.
Receiver: HDMI Type-A female connector for video output.
3
Audio In
3.5mm jack for connecting an external active microphone.
4
Audio Out
3.5mm jack for connecting an active loud speaker.
5
DC 12V
12V/2A DC power input.
Only use one power source, either from DC or from 802.3af/at PoE+
Ethernet switch.
6
ACT/Link
ACT: ACT LED indicator turns blue when the device is powered up.
Link: Link LED indicator flickers green when network connection is
waiting for video source, turns green when network connection and
video source is functioning properly.
7
RS232
DB-9 female connector for RS232 bi-directional remote extension.
8
IR
Transmitter: 3.5mm jack for IR emitter cable to control video source device.
Receiver: 3.5mm jack for IR receiver cable to receive signal from remote
controller.
9
PC USB
USB Host input Port.
10
Group
Group configuration, 4-bit switch for 16 stream channel selection.
11
Reset
This button supports two functions: “Restore to factory default setting” and
“Stop connecting to video source”.
Restore to factory default setting:
