User Manual of WDAP-802AC
-12-
Step 1.
(1) Install the Backplane to the back of the AP.
(2) Attach the L-type bracket to it.
(3) Assemble the AP to the pole by using the U-bolt kit.
※
The AP can be mounted on an up to 2.5” (O.D.) pole.
Figure 3-1
Installing Backplane and Bracket
Step 2.
(1) Attach the surge arrestors to each antenna connector.
(2) Attach the antenna equipped with N-type (M) connector to each surge arrestor. Otherwise, connect
the antenna through the N-male (male pin) to N-male (male pin) cable.
(3) Plug the RJ45 Ethernet cable into the PoE port of the AP through the waterproof kit, and plug the
other side of the RJ45 cable into the PoE port of the PoE switch to finish the installation.
※
Please remember to finish grounding by consulting the local electrical experts.
Figure 3-2
Connecting Antennas and Ethernet Cable
