Page 2
Safety Instructions
For your own safety, and to protect your Print Server, please observe the following
safety advice.
1. Unplug this device from its power source before cleaning. Use only a slightly
dampened cloth for cleaning. Do not use liquid or aerosol cleaners.
2. Avoid using this product near water. Exposure to water poses an electric-shock
hazard.
3. Do not place the Print Server on an unstable surface. The device may fall causing
serious damage to the device.
4. This device should only be used with the power supply type specified on the mark-
ing label. If you are not sure of type of your local power supply, consult your dealer
or the local power company.
5. Do not pinch, crimp or otherwise damage the power cord. If exposed to foot traffic,
ensures that the cable is properly shielded and does not pose a tripping hazard.
6. If using an extension cord, makes sure the total ampere rating of the products us-
ing the cord does not exceed the extension cord's ampere rating.
7. Do not attempt to service this device, as opening or removing casing may expose
you to dangerous voltage points or other risks. Refer all servicing to qualified ser-
vice personnel.
8. The Print Server should be serviced by qualified service personnel under the fol-
lowing conditions:
•
The power cord is damaged or frayed.
•
Liquid has been spilled onto the product.
•
The product has been exposed to rain or water.
•
The product does not operate normally in accordance with the operating in-
structions.
•
The device has been dropped or the casing has been damaged.
