20
3.1 Desktop Installation
To install the 802.3at PoE+ Switch on desktop, simply follow the following steps:
Step 1:
Attach the rubber feet to the recessed areas on the bottom of the
802.3at PoE+ Ethernet Switch, as shown in Figure 3-1.
1
PWR
5
9
13
17
21
3
7
11
15
19
23
PoE
2
6
10
14
18
22
4
8
12
16
20
24
PoE
24-Port 10/100/1000T
802.3at PoE
+2-Port Gigabit
SFP Ethernet Sw
itch
SFP
26
4
6
8
2
1
3
5
7
12
14
16
10
9
11
13
15
20
22
24
18
17
19
21
23
PoE Port Status
GSW-2620VHP
PoE In-Use
ACT
LNK
1000
ACT
LNK
10/100
ACT
LNK
SFP
25 26
25
Standard
VLAN
Extend
Figure 3-1:
Attaching the Rubber Feet to the 802.3at PoE+ Switch
Step 2:
Place the 802.3at PoE+ Switch on desktop near an AC power source.
Step 3:
Keep enough ventilation space between the 802.3at PoE+ Switch and the
surrounding objects.
Note
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4, under Specifications.
Step 4:
Connect your 802.3at PoE+ Switch to 802.3af/802.3at complied Power
Devices (PD) and other network devices.
A.
Connect one end of a standard network cable to the 10/100BASE-TX
RJ45 ports on the front panel of the 802.3at PoE+ Switch.
B.
Connect the other end of the cable to the network devices such as
printer servers, workstations or routers, etc.
Note
Connection to the Switch requires UTP Category 5, 5e, 6 network
cabling with RJ45 tips. For more information, please see the
Cabling Specification in Appendix A.