26
3.5 Power over Ethernet Powered Devices
3~5 watts
Voice over IP Phones
As many as PoE VoIP phones, ATAs and other Ethernet/
non-Ethernet end-devices can be installed, but UPS is
needed for uninterrupted power system and power control
system.
6~12 watts
Wireless LAN Access Points
Access points can readily be installed in museums,
sightseeing sites, airports, hotels, campuses, factories and
warehouses.
10~12 watts
IP Surveillance
For the sake of security, install IP cameras around
enterprises, museums, campuses, hospitals and bank
without considering location and electrical outlets.
3~12 watts
PoE Splitter
As PoE Splitter splits the PoE 48V DC over the Ethernet
cable into 5/12V DC power output, network deployments
can easily be made without worrying about power outlet
locations, thus eliminating the costs for additional AC
wiring and reducing the installation time.
3~25 watts
High Power PoE Splitter
As PoE Splitter splits the PoE 53V-54V DC over the
Ethernet cable into 24/12V DC power output, network
deployments can easily be made without worrying about
power outlet locations, thus eliminating the costs for
additional AC wiring and reducing the installation time.
30 watts
High Power Speed Dome
This state-of-the-art design fits very nicely in various
network environments like traffic centers, shopping malls,
railway stations, warehouses, airports and production
facilities for the most demanding outdoor surveillance
applications. Electrician is not needed to install AC sockets.
Note
Since each port of the 802.3at PoE+ Switch supports 53V-54 DC
PoE power output, please make sure the Powered Device’s (PD)
acceptable DC power range is from 53V-54 DC. Otherwise, it will
damage the Powered Device (PD).
