User’s Manual of ICA-2200
II
Copyright
Copyright
©
2012 by PLANET Technology Corp. All rights reserved. No part of this publication
may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language or computer language, in any form or by any means, electronic, mechanical, magnetic,
optical, chemical, manual or otherwise, without the prior written permission of PLANET.
PLANET makes no rep resentations or warranties, either expressed or implied, with respect to
the contents hereof and specifically disclaims any warranties, merchantability or fitness for any
particular purpose. Any software described in this manual is sold or licensed "as is". Should the
programs prove defective following their purchase, the buyer (and not PLANET, its distributor, or
its dealer) assumes the entire co st of all necessary servicing, repair, and any incident al or
consequential damages resulting from any defect in the software. Further, PLANET reserves the
right to revise this publi cation and to make changes from time to time in the content s hereof
without obligation to notify any person of such revision or changes.
All brand and product names mentioned in th is manual are trademarks and/or registered
trademarks of their respective holders.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rul es. These limits are designed to provide reasonable protection
against harmful interference in a re sidential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accorda nce with the
instructions, may cause harmful interference to ra dio communications. However, there is n o
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or tel evision reception, which can be determined by turning t he
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit dif ferent from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio technician for help.
FCC Caution
To assure continued compliance. (Example-use only shielded interface cables when connecting
to computer or peripheral devices). Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two
conditions: ( 1 ) Thi s device may not cause harmful interference, and ( 2 ) this Devi ce must
accept any interference received, including interference that may cause undesired operation.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure set forth for an uncontrolled environment.
In order to a void the possibility of exceeding the FCC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.
