Industrial 5G NR Cellular Gateway
ICG-2515-NR series
- 73 -
4.5.7 WAN IPv6 Setting
This page is used to configure parameter for IPv6 internet network which connects to WAN port of the
cellular gateway as shown in
Figure 4-5-9
. It allows you to enable IPv6 function and set up the
parameters of the cellular gateway’s WAN. In this setting you may change WAN connection type and
other settings.
Figure 4-5-9:
IPv6 WAN setup
Object
Description
Connection Type
Select IPv6 WAN type either by using DHCP or Static.
IPv6 Address
Enter the WAN IPv6 address.
Subnet Prefix Length
Enter the subnet prefix length.
Default Gateway
Enter the default gateway of the WAN port.
4.5.8 DHCP
The DHCP service allows you to control the IP address configuration of all your network devices. When
a client (host or other device such as networked printer, etc.) joins your network it will automatically get
a valid IP address from a range of addresses and other settings from the DHCP service. The client
must be configured to use DHCP; this is something called "automatic network configuration" and is
often the default setting. The setup is shown in
Figure 4-5-10
.
