15
5. Hardware Installation
The following section describes the hardware features of the IPOE-171
series. Before connecting any network device to it, please read this
chapter carefully.
5.1 Before Installation
Before your installation, it is recommended to check your network
environment. If there is any IEEE 802.3bt device that needs to be
powered on and works normally, the IPOE-171 series is the solution
that supplies power to this Ethernet device conveniently and easily. If
there is difficulty in finding a power socket for the AC-DC connection
to your non-IEEE 802.3at/bt networked device, the IPOE-171 series
with POE-173S/IPOE-173S can supply DC power to this Ethernet device
conveniently and easily.
Note
1.
In the installation steps below, this manual uses
the IPOE-171-60W as an example. Except the input
voltage, the steps for the IPOE-171-95W are similar.
2. Note that the input power range of the IPOE-171-60W
is
48 ~ 54V DC
and the input power range of IPOE-
171-95W is
12 ~ 54V DC
.
5.2 IPOE-171-60W/IPOE-171-95W Installation
1. Connect the power ranging from 12V/48V DC to 54V DC to the
6-pin terminal block of the IPOE-171-60W/IPOE-171-95W. The
power LED will be steadily on.
2. Connect a standard Ethernet cable from an Ethernet switch or
PC workstation to
“Ethernet”
port of the IPOE-171-60W/IPOE-
171-95W.
3. Connect the long cable to the “EDC” port.
