PLANET NAS-7400 User Manual
141
iv.
In the confirmation box, click the OK button.
v.
Wait until the LEDs on the front of the NAS-7400 go dark.
vi.
Disconnect the power cord, network cable, and USB cable.
Remove and Replace the Fan
i.
Remove the four screws on the back of the enclosure.
ii.
Carefully remove the back panel from the enclosure.
iii.
Disconnect the fan power harness from its connector on the
motherboard.
iv.
Gently pull the two retainer clips away from the cooling fan.
v.
Lift the cooling fan off the locating pins.
vi.
Check the direction arrow on the new fan to be sure it blows
outward.
vii.
Align the new fan with the locating pins on the back panel and
gently press the fan into place on the panel.
viii.
The fan snaps into place between the retainer clips.
ix.
Reconnect the fan power harness to its connector on the
motherboard.
x.
Place the back panel onto the enclosure and install the four screws
to attach the back panel to the enclosure.
Reconnect and Power-up
i.
Reconnect the power cord, network cable, and USB cable.
ii.
Press the Power Button on the front of the NAS-7400 (right).When
the NAS-7400 is fully booted:
The System Status LED turns green
The buzzer beeps one time (if the buzzer is enabled)
Power Button
System
Status
