PLANET NAS-7400 User Manual
140
vi.
In the File Name field, type the name of the plug-in file.
vii.
Click the OK button to begin the installation.
Note
Do not disconnect the power or shut down the NAS-7400 while
the installation is running!
When the installation is done, a system message appears.
Click the OK button on the system message.
Rebooting the NAS-7400
To reboot the NAS-7400 after a plug-in installation:
i.
In the Tree, click on the + beside the System icon.
ii.
Click on the Reboot / Shutdown icon.
iii.
Click on the Reboot option.
iv.
Click the OK button.
v.
In the confirmation box, click the OK button.
vi.
The reboot runs automatically. When the NAS-7400 is fully booted:
vii.
The System Status LED turns green (right)
viii.
The buzzer beeps one time (if the buzzer is enabled)
Replacing the Fan
Follow this procedure to replace the disk drive cooling fan on the NAS-7400:
Shutdown and Disconnect
i.
In the Tree, click on the + beside the System icon.
ii.
Click on the Reboot / Shutdown icon.
iii.
Click the Shutdown option and click the OK button.
System Status LED
