VIP-2100 User
’
s manual
- 132 -
VIP-2100 FAQ
Q1. Forgotten user password to logon VIP-2100.
Answer:
a. Logon by a user has Administrator right to reset the user
’
s password
b. Use the LCD control panel to change the user id: admin or root
’
s
password.
Q2.
In H.323 Mode
: Cannot hear ring back tone for PSTN caller.
Answer:
Normally, the ring back tone is generated by the nearest PABX
connected to VIP-2100. If a caller from PSTN site cannot hear the ring back
tone, please check:
a. Consult to PABX/PSTN vender to clarify the PABX/PSTN will generate
ring back tone.
b. For Fast Start mode, make sure the far end VoIP end point will have
ring tone generated. For example, a PSTN subscriber calls a VoIP
H.323 IP Phone. When it is on Fast Start mode, VIP-2100 will cut
through the voice path after receive Fast Start Ack. Please make sure
the Far End VoIP Endpoint will generate ring back tone over RTP
media path to VIP-2100.
c. If you really need VIP-2100 to generate PSNT ring back tone, please
do the following setting:
-
Turn on
“
local ring back
”
from
“
Interface -> Trunk
”
for each
trunk required local ring back tine generation.
-
Disable Fast Start for H.323 outgoing call (set to disable or
H.323 incoming call only.)
Q3.
In H.323 Mode
: VIP-2100 cannot keep registering to Gatekeeper after
Gatekeeper restarted.
Answer:
a. Check whether VIP2100
’
s register time to live is too long or not. If yes,
make it shorter from
“
H.323 -> Register Time to Live
”
. If we make it
longer, it means it might need take long time to re-register to
Gatekeeper after Gatekeeper failed or restart. If it is very short, will
cause more IP traffic.
b. Check whether Gatekeeper has a preset TTL setup or not. If so, the
GK TTL will overwrite the VIP-2100
’
s TTL request by using the default
value.
Q4.
In SIP Mode
: VIP-2100 cannot keep registering to SIP Register
Server after Register Server restarted.
Answer:
a. Check whether VIP-2100
’
s registar IP address, port, user id and
password are correct.
b. Check whether Register Server has a preset TTL setup or not. If so,
the Register Server TTL will overwrite the VIP-2100
’
s TTL request by
using the default value.
Summary of Contents for VIP-2100
