VIP-2100 User
’
s manual
- 69 -
DNIS ACL
Start Path:
Configuration
→
Access Control
→
DNIS ACL
Figure 7.7-3
Parameters:
•
DNIS: Called party number used for filter
•
Access Mode:
o
Allow: The called numbers are allowed for calls
o
Disallow: The called numbers are disallowed for calls
☻
Note: If in the system has both allowance and disallowance setup, the
system will check allowance first and disallowance later. If only
disallowance inputted all DNIS will allow to work except
disallowed DNIS. If only allowance inputted, only those DNIS
from allowance list will work.
User ACL
User ACL is used to store subscriber information when internal AAA is
enabled.
Start Path:
Configuration
→
Access Control
→
User ACL
Figure 7.7-4
Parameters:
•
User: User ID (0~9, *#)
•
Password: Password (0~9, *#)
•
Prepaid Point: Allowed prepaid point (When prepaid point is used, the
system will deduct it automatically base on the rate setting.)
o
Postpaid: postpaid user
•
Status:
o
Active: User is activeled
o
Inactive: User is inactived
☻
Note: 1. IP Authentication method must be set to
“
internal AAA
”
to
talk effect.
Summary of Contents for VIP-2100
