8
9
Chapter 4
CONFIGURING THE SYSTEM
This chapter provides network managers and system administrators with information
about how to configure the WMC-1600R via the Management interface.
4.1 Configure Through Terminal Emulator/TELNET Program
4.1.1 Console and Terminal Emulator program setting
The WMC-1600R can be accessible using a terminal or terminal emulator attached to the
RS-232 serial port.
1.Locate correct DB9 serial port cable with female DB9 connector.
2.Attach the DB9 serial port female cable connector to the male DB9 serial port connector
on the chassis system.
3.Attach the other end of the DB9 serial port cable to a remote the workstation.
4.By default, the Management Module uses the following serial port parameter values:
Bits per second
57600
Stop bits
1
Data bits
8
Parity
NONE
Flow Control
NONE
The default Login name and password is both “
root
".
4.1.2 TELNET program setting
The WMC-1600R can be accessible using TELNET through LAN.
1. Run TELNET program.
2. Enter the IP address "
192.168.1.1
" (the factory-default IP address setting).
3. The default Login name and password is both "
root
".
