14
15
4.1.3.3 SNMP Configuration
Get Community Name:
to get the device community name (default = public).
Set Community Name:
to set the device community name (default = private).
Trap Community Name:
to authorize the device trap community name (default =
public).
Trap Host IP Address:
to set the trap host IP address (same as monitoring station IP
address).
Cold Start trap:
to set the trap for rebooting the device (default = enable).
Warm Start trap:
to set the trap when the device had been reset (default = enable).
Authentication Fail Trap:
to set the warning trap when the community name of the
device and workstation are different (default = enable).
Power Fail Trap:
to set the Power Fail Trap (default = enable).
Fan Fail Trap:
to set the fan fail trap (default = enable).
MC Plug-in Trap:
to set the trap when a Media Converter module has been plugged in
(default = enable).
MC Pullout Trap:
to set the trap when the Media Converter module has been pulled out
(default = enable).
MC Broken trap:
to set the trap when the Media Converter module was broken (default
= enable).
MC Link up trap:
to set the trap when a linking is connected (default = enable).
MC Link down trap:
to set the trap when a linking is disconnected (default = enable).
MC Active Slot Xchg trap:
to set the trap when there is a redundant function activated
(default = enable).
MC Active Slot Lose trap:
to set the trap when the redundant function is fail (default
= enable).
