– 5 –
– 6 –
1. Insert the positive DC power wire into the po)
contact (right pin) and tighten the wire-clamp for
preventing the DC power wire from loosening.
2. Insert the negative DC power wire into the negative(-)
contact (middle pin) and tighten the wire-clamp for
preventing the DC power wire from loosening.
3. Insert the grounding power wire into the grounding(G)
contact (left pin) and tighten the wire-clamp for
preventing the power wire from loosening.
Figure 4-1
Power pin design of XGS3-PWR150-48
5. Removing Redundant Power
Supply Unit
Follow these steps to install the redundant power into the
Switch:
1. Remove all DC power wires from terminal block of the
XGS3-PWR150-48.
2. To remove the redundant power from the XGS3-24042,
move the lever to the right and pull it out.
Figure 5-1
Removing the XGS3-PWR150-48
