Chain Hoist PREMIUM PRO-E
10
5.3 Maintenance
5.4 Lubrication instruction
The measurement has to be carried out as follows:
– Take the throut of the hook from metal to metal, without the safety latch
– The wear on the bottom of hook throat should not exceed 10% from origi
-
nale dimension
– Check the sideways twist of the hook. I fit exceeds 10 degrees from planar
-
ity, the hook has to be replaced
– Check the safety latch for positive closing and free movement. Replace
when damaged !
– Excessive damage on the hooks, due to chemical or corrosive influences,
cause their replacement.
– It is strictly forbidden to grind or weld for repairs on the hooks.
These thorough examiations can only be carried out by a lifting equipment ex-
pert. If you dont have this knowledge, contact your supplier or us. We carry out
regularly examinations, also by service contract.
After completion of use take care of:
– Wipe away dirt and water, slightly lubricate the lifting chain and rotating
parts.
– From time to time – depending on the number of uses – check if the gear-
box wheels are still greased sufficiently
Lubricate all movable parts (gear wheels etc.) slightly with Molikote grease
Exception: Never lubricate any brake part
When not in use, store the hoist in a dry place.
A proper function is only warranted with use of original spare parts
If the device has to be checked or repaired in a case of warranty, please send
it completely assembled. We cannot accept any warranty claims with receival
of disassembled devices.
twisting
