15
FLAME HEIGHT REGULATION
When the flame is ignited (
WORKING
), press
+
or
–
to make the flame higher or lower in 6 levels. The default flame
height is 4.
ATTENTION!
In case the device temperature is too high, the flame will be automatically lowered and the height
regulation blocked. If the temperature keeps increasing, the flame will be extinguished (
COOLING THE DEVICE
,
TEMPERATURE TOO HIGH
).
FLAME EXTINGUISHING
To extinguish the flame:
- press
or
- press
STOP
.
In this case, an additional system of fans will be enabled to cool the device faster.
Message
COOLING THE DEVICE
indicates that the device is being cooled. You can ignite the flame again when
the device is cooled
– message
READY
.
TURNING THE DEVICE OFF
To turn the device OFF, press
.
The device will be turned OFF automatically once any error occurs (see the error table on the next page).
SLEEP FUNCTION
The
SLEEP
function extinguishes the flame after a set period of time (max. 3 hours).
When the flame is ignited (
WORKING
), press and hold
+
and
–
for 10 seconds. Then, press
+
to set the time after
which the flame will be extinguished and accept with
–
. A timer will appear in the right upper corner of the display,
indicating the time remaining to flame extinguishing.
MENU
The menu is available when messages
READY
or
NO FUEL
are displayed. To enter the menu, press and hold
+
for 8
seconds. Scroll through the settings with
+
and accept by pressing
–
. To quit the menu, wait for couple of seconds or
press
.
EN
GL
ISH
